STANDARD INSTALLATION SERVICES
- Building permit for gas piping and 120 gallon propane container
- Installation of 120 gallon propane container with gas regulator and container foundation
- Installation of gas piping from propane container to gas fire log appliance
- Gas main pressure test
- Fire log assembly
- Fire log test firing and consumer instructions on the use and maintenance of the fire log appliance instructions
- Gas Check Inspection and Consumer Orientation to your propane gas energy system
- Coordination of Town Inspections
STANDARD PROPANE GAS ENERGY FIRE LOG INSTALLATION DIAGRAM
 ONE CALL DOES IT ALL
After you’ve chosen your Firelog from your Retail dealer, make ONE call to SUPERIOR.
We will coordinate everything including Permits, Firelog and propane storage tank Installation; and we will even accept payments
PRICES
Standard Fire Log – Propane Energy
Installation Price $475.00
PAYMENT OPTIONS
Make three monthly payments of $185.00 each pending a credit approval
ADDITIONAL PRICES & CONDITIONS
ADDITIONAL CHARGES: The above installation price is based on standard installation services stated above and will be confirmed prior to work commencement. Payment is required at the time installation is completed. Additional charges may apply for non standard installations. Permit fees, fuel and customer services charges for leased propane storage, gas regulations system and sales tax where applicable are not included and will be charged separately. Prices may change without notice. See diagram of standard installation on reverse side of this page.
PROPANE CONTAINER REQUIREMENTS
Container must be accessible to fill. Container must conform to NFPA 58 FIRE CODE STANDARD regarding minimum distances to various building openings, sources of ignition and other applicable exposures.
Notes:
- Regardless of its size, any ASME tank filled on-site must be located so that the filling connection and fixed liquid level gauge are at least 10 feet from external source of ignition (i.e. open flame, window A/C, compressor, etc.), intake to direct vented gas appliance or intake to a mechanical ventilation system.
- May be reduced to 10 feet minimum for a single container of 1200 gallons water capacity or less if it is located at least 25 feet from any other LP-Gas container of more than 125 gallons water capacity.
- Minimum distances from underground containers shall be measured from the relief valve and filling or level gauge vent connection at the container, except that no part of an underground container shall be less than 10 feet from a building or line of adjoining property which may be built upon.
- Where the container may be subject to abrasive action or physical damage due to vehicular traffic or other causes it must either a) placed not less than 2 feet below grade: b) otherwise protected against such physical damage.must
The separating distance between a private well water supply system and an underground propane storage tank system is as follows:
If propane tank has a water capacity of less than 2000 gallons = 25 feet
If propane tank has a water capacity greater than 2000 gallons = 50 feet
*In addition, propane system should be at least 10 feet from septic/leach fields.
NOTE: A PROPANE STORAGE TANK SYSTEM INCLUDES THE STORAGE TANK, PIPING AND OTHER EQUIPMENT ASSOCIATED WITH STORAGE, OR THE TRANSFER OF THE PROPANE FROM STORAGE.
Underground Tank Requirements:
For trench:
Underground line to the tank must be 18 inches below ground level, (with a 4-6 inch sand base), or 24 inches below ground level if it is to be driven over, (such as a driveway, etc.).
Typical 120 gallon tanks used for residential installations
Exterior propane gas line (run from the tank to the house)
Exterior propane gas line (run from the tank to the house)
Underground 500 gallon tank – typically used for home heating
Typical 120 gallon horizontal tanks used for residential installations
|
